Many users often ignore the connecting ground wire when using the UV flat-panel printer. In fact, this operation is very important. Therefore, when installing and using the UV flat-panel printer, users must do a good job in grounding and anti-static protection for the UV flat-panel printer.

Now, the sockets in general household or office environment will be equipped with grounding wire. We can connect the grounding wire by directly inserting the socket. If your office environment does not have grounding facilities, how should we deal with it without grounding wire? How to properly operate the grounding wire of UV flat panel printer? Let's have a look!

If your UV flat-panel printer's office environment is on the first floor, if conditions permit, you can directly use a steel bar or iron column on the non cement floor to drive it into the ground from the floor, then use the wire and copper wire to tie the steel bar and expose the copper wire, then pour salt water into the pit, fix the position, and connect the copper wire to the UV flat-panel printer. If conditions do not permit, for example, in the second floor or other environment where pits cannot be dug, it can be extended to the downstairs through wires and then grounded, or relevant containers, such as barrels or other containers, and then put salt coated, connect the ground wire with an angle iron inside, connect a copper wire to the downstairs, and finally use mineral water bottles to fill more salt and add some water to put the ground wire in. This method is relatively simple, but it cannot last. Of course, a better way is to let professionals connect the ground wire once and for all.